Keep feet clear of Mower Deck when adjusting height. Failing to do so, could
pinch feet if they under Deck.
Engaging the Blades
1. Engage Blades by pulling up on Blade Control Switch (Figure 36).
Stopping the Blades
1. Push down on Blade Control Switch (Figure 36).
Adjusting the Mower Deck Height
Note: The DR TOW-BEHIND FIELD and BRUSH MOWER Deck cutting Height
ranges from a minimum of 4 in to a maximum of 7.5 in.
1. To lower cutting Height of Mower, press “Lower” on Rocker Switch
(Figure 37) until Sway Brace is aligned with desired cutting height lines on
Height Adjust label (Figure 38).
2. To raise cutting Height, press “Raise” on Rocker Switch until Sway Brace is
aligned with desired cutting height lines on Height Adjust label.
• Shut off Brush Mower Engine before adjusting Deck height or serious injury
may result. Blades could sever feet if they go under the deck with the
Engine running.
• Never get off Tow Vehicle without first stopping Blades and shutting off Tow
Vehicle Engine.
To Next Page
Loading...
