DR PREMIER 44T - User Manual

36 pages

To Next Page

To Next Page

Loading...

Serial No.

Order No.

Read and understand this manual and all instructions before operating the TOW BEHIND DR TOW-BEHIND FIELD

and BRUSH MOWER.

DR

®

TOW-BEHIND FIELD and BRUSH MOWER

SAFETY & OPERATING INSTRUCTIONS

DR Power Equipment

Toll-free phone: 1-800-DR-OWNER (376-9637)

Website: www.DRpower.com

Models:

PREMIER 44T

PRO 44T

PRO-XL 44T

Questions and Answers

K
Kerry WaltonAug 18, 2025
What to do if DR PREMIER 44T engine lacks power or is not running smoothly?
- S
  Shirley TapiaAug 18, 2025
  If your DR Lawn Mower engine lacks power or isn't running smoothly, check the Throttle Lever to ensure it's in the RUN position. The Air Filter, Spark Plugs may be dirty or cracked and should be changed. If the Spark Plug is oily, remove it, hold a rag over the plug hole, and crank the engine to blow out oil, then clean and reinsert the plug. Make sure the gas is fresh and clean. If the gas is old, replace it. Also, ensure the engine has the correct amount of clean oil; if it’s dirty, change it.
A
Ashley HarrisAug 22, 2025
What to do if blades vibrate when engaged on DR Lawn Mower?
- C
  carlameyerAug 22, 2025
  If the blades vibrate when engaged on your DR Lawn Mower, first ensure the Blade Carrier Mounting Bolt is tightened as much as possible by hand with a 1ft long 1-1/8" Wrench. Also check if a Swinging Blade is too loose on the Blade Carrier and re-tighten its mounting hardware. Replace any Swinging Blade that is chipped, bent, or broken. The Spindle Bearings may be damaged or the Spindle Shaft may be bent.
K
Kaitlyn BaileyAug 25, 2025
How to fix DR Lawn Mower blades that are not cutting or are loose?
- G
  Gregory MillerAug 26, 2025
  If the blades on your DR Lawn Mower are not cutting or are loose, make sure the Blade Carrier Mounting Bolt is tightened as much as possible by hand using at least a 1ft long 1-1/8” Wrench. Also, check if any Swinging Blades are too loose on the Blade Carrier and re-tighten the mounting hardware. The Swinging Blades may also be dull or nicked, so sharpen them.
T
Theresa PriceAug 28, 2025
What causes the belt to fray or roll over the pulley on a DR PREMIER 44T Lawn Mower?
- C
  Carla WilsonAug 28, 2025
  If the belt on your DR Lawn Mower frays or rolls over the pulley, there might be a nick in a Pulley groove. Check the Belt for wear and hard spots. Also, the Belt may be stretched and need replacement.
Z
Zachary GarciaSep 1, 2025
Why is my DR Lawn Mower engine smoking?
- A
  Adam GlassSep 1, 2025
  If your DR Lawn Mower engine is smoking, start by checking the oil level and adjust as needed. It's possible you're operating the machine on too steep of an incline. Inspect the Air Filter and clean or replace it if necessary. You might be using an oil that's too light for the current temperature. Also, ensure the Cooling Fins and Carburetor housing are clean.
J
jgoodmanSep 4, 2025
Why won't the blades engage or disengage on my DR PREMIER 44T?
- M
  Matthew RodriguezSep 4, 2025
  If the blades on your DR Lawn Mower won't engage or disengage, the Blade Control Switch may be faulty and needs to be replaced. A low or weak battery may cause electric clutch to not engage, so check battery for sufficient voltage.
A
alexandraelliottSep 7, 2025
How to fix an uneven cut with DR Lawn Mower?
- R
  reginald04Sep 8, 2025
  If your DR Lawn Mower is leaving an uneven cut, it's likely that the Left and Right Deck Height Adjusters are not set at the same height. Adjust them to the same setting.
D
David TaylorSep 12, 2025
What causes excessive engine stalling in DR PREMIER 44T Lawn Mower?
- B
  Beth WilsonSep 12, 2025
  Excessive engine stalling in your DR Lawn Mower can occur if the brush or grass is too heavy for the current cutting height or the towing vehicle speed. Try raising the cutting height and driving slower when cutting.
B
Brent MayerNov 14, 2025
Why won't my DR PREMIER 44T engine start?
- A
  Amanda CarrollNov 14, 2025
  If your DR Lawn Mower engine won't start, several issues could be the cause. First, make sure that the Blade Control Switch is in the DOWN Disengaged position and that the Spark Plug wire is attached. For a cold engine, ensure the Throttle is in the CHOKE position. The gas must be fresh and clean. Old gas should be replaced. Dirty or cracked Spark Plugs should be replaced. If the Spark Plug is oily, remove it, cover the plug hole with a rag, and crank the engine to clear oil from the cylinder, then clean and reinsert the plug. Check the air filter and replace if needed, following the Engine Owner’s Manual. Also, inspect the fuses in the wiring harness and replace them if necessary. Check all wire connections, especially the ground connection (the large green wire from the Battery to the En...

DR PREMIER 44T Specifications

General

Brand	DR
Model	PREMIER 44T
Category	Lawn Mower
Language	English

Summary

Chapter 1: General Safety Rules

Safety Labels and Warnings

Displays and describes safety labels, warnings, and operational notices.

Safe Operating Practices

Outlines essential safety measures for personal protection and machine operation.

Environmental and Legal Notices

Covers slope operation, California Prop 65, and other user advisories.

Chapter 2: Setting Up Your DR TOW-BEHIND FIELD and BRUSH MOWER

Controls and Features Overview

Identifies and describes the main controls and features of the mower.

Premier Model Specifics

Details the specific controls and features for the Premier model.

Machine Specifications

Assembling Your DR TOW-BEHIND FIELD and BRUSH MOWER

Tow Bar and Remote Control Connection

Instructions for attaching the tow bar and connecting the remote control system.

Adding Fluids and Connecting Battery

Steps for filling oil/gas, connecting the battery, and checking tire pressure.

Tow Vehicle Attachment and Remote Mounting

Procedures for hitching to a tow vehicle and mounting the remote control.

Chapter 3: Operating the DR TOW-BEHIND FIELD and BRUSH MOWER

Operating Parameters and Tow Vehicle Selection

Recommends tow vehicles and outlines operational restrictions and parameters.

Engine Starting, Stopping, and Blade Control

Covers clutch break-in, pre-start checks, starting, and stopping procedures.

Deck Height, Offset Mowing, and Tow Bar Configuration

Details on adjusting deck height, setting up offset mowing, and changing tow bar direction.

Slopes, Hung Ups, and Wet Growth Operation

Safety and operational advice for slopes, hung-up situations, and wet conditions.

Chapter 4: Maintaining Your DR TOW-BEHIND FIELD and BRUSH MOWER

Regular Maintenance Checklist and Lubrication

A schedule of routine maintenance tasks and lubrication procedures.

Engine Oil, Filter, Drive Belt, and Blade Replacement

Procedures for replacing engine oil, filter, drive belt, and mower blades.

Carbon Canister and Battery Care

Maintenance steps for the carbon canister and guidelines for battery care.

Chapter 5: Troubleshooting

Common Engine and Blade Issues

A table listing common symptoms and their possible causes and solutions.

Advanced Troubleshooting and Belt Problems

Further troubleshooting steps for engine smoke, belt issues, and blade problems.

Chapter 6: Parts Lists and Schematic Diagrams

Frame, Deck, and Drive Assembly Parts Lists

Detailed lists of parts for the mower's frame, deck, and drive assemblies.

Assembly Schematics

Exploded view diagrams illustrating the frame, deck, and drive assembly components.

2-Year Limited Warranty Terms and Conditions

Daily Checklist and Storage Guide

End of Season and Storage Procedures

Instructions for preparing the mower for storage and end-of-season maintenance.

Related product manuals

Preview: DR PREMIER 26"

Preview: DR PULSE Series

DR PULSE Series

Preview: DR PRO

Preview: DR Field

Preview: DR SPRINT PRO

Preview: DR ALL-TERRAIN

DR 14.5HP PRO-26

Preview: DR 10.5HP PRO-26

DR 10.5HP PRO-26

DR 16.5HP PRO XL 30

Preview: 7.25 ALL-TERRAIN TRIMMER/MOWER

7.25 ALL-TERRAIN TRIMMER/MOWER