EasyManua.ls Logo

DR PRO-XL 44T - User Manual

DR PRO-XL 44T
36 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Serial No.
Order No.
Read and understand this manual and all instructions before operating the TOW BEHIND DR TOW-BEHIND FIELD
and BRUSH MOWER.
DR
®
TOW-BEHIND FIELD and BRUSH MOWER
SAFETY & OPERATING INSTRUCTIONS
DR Power Equipment
Toll-free phone: 1-800-DR-OWNER (376-9637)
Website: www.DRpower.com
Models:
PREMIER 44T
PRO 44T
PRO-XL 44T

Questions and Answers

  • D
    David CampbellAug 17, 2025
    What to do if DR PRO-XL 44T engine lacks power or is not running smoothly?
    • G
      georgewaltersAug 18, 2025
      If your DR Lawn Mower engine lacks power or isn't running smoothly, check the Throttle Lever to ensure it's in the RUN position. The Air Filter, Spark Plugs may be dirty or cracked and should be changed. If the Spark Plug is oily, remove it, hold a rag over the plug hole, and crank the engine to blow out oil, then clean and reinsert the plug. Make sure the gas is fresh and clean. If the gas is old, replace it. Also, ensure the engine has the correct amount of clean oil; if it’s dirty, change it.
  • T
    Tim NicholsonAug 21, 2025
    What to do if blades vibrate when engaged on DR Lawn Mower?
    • R
      Robin ThomasAug 21, 2025
      If the blades vibrate when engaged on your DR Lawn Mower, first ensure the Blade Carrier Mounting Bolt is tightened as much as possible by hand with a 1ft long 1-1/8" Wrench. Also check if a Swinging Blade is too loose on the Blade Carrier and re-tighten its mounting hardware. Replace any Swinging Blade that is chipped, bent, or broken. The Spindle Bearings may be damaged or the Spindle Shaft may be bent.
  • T
    Tricia ParsonsAug 25, 2025
    How to fix DR Lawn Mower blades that are not cutting or are loose?
    • X
      xgrantAug 26, 2025
      If the blades on your DR Lawn Mower are not cutting or are loose, make sure the Blade Carrier Mounting Bolt is tightened as much as possible by hand using at least a 1ft long 1-1/8” Wrench. Also, check if any Swinging Blades are too loose on the Blade Carrier and re-tighten the mounting hardware. The Swinging Blades may also be dull or nicked, so sharpen them.
  • M
    Marcus HarringtonAug 28, 2025
    What causes the belt to fray or roll over the pulley on a DR PRO-XL 44T Lawn Mower?
    • A
      Aimee BrownAug 28, 2025
      If the belt on your DR Lawn Mower frays or rolls over the pulley, there might be a nick in a Pulley groove. Check the Belt for wear and hard spots. Also, the Belt may be stretched and need replacement.
  • D
    Daniel HuntAug 31, 2025
    Why is my DR PRO-XL 44T Lawn Mower engine smoking?
    • M
      Michael HughesAug 31, 2025
      If your DR Lawn Mower engine is smoking, start by checking the oil level and adjust as needed. It's possible you're operating the machine on too steep of an incline. Inspect the Air Filter and clean or replace it if necessary. You might be using an oil that's too light for the current temperature. Also, ensure the Cooling Fins and Carburetor housing are clean.
  • T
    Tricia WaltonSep 3, 2025
    Why won't the blades engage or disengage on my DR PRO-XL 44T?
    • B
      Brenda JonesSep 4, 2025
      If the blades on your DR Lawn Mower won't engage or disengage, the Blade Control Switch may be faulty and needs to be replaced. A low or weak battery may cause electric clutch to not engage, so check battery for sufficient voltage.
  • E
    Emily MendezSep 6, 2025
    How to fix an uneven cut with DR Lawn Mower?
    • T
      Timothy ShawSep 6, 2025
      If your DR Lawn Mower is leaving an uneven cut, it's likely that the Left and Right Deck Height Adjusters are not set at the same height. Adjust them to the same setting.
  • N
    Nicole BellSep 10, 2025
    What causes excessive engine stalling in DR PRO-XL 44T Lawn Mower?
    • K
      Kevin LopezSep 10, 2025
      Excessive engine stalling in your DR Lawn Mower can occur if the brush or grass is too heavy for the current cutting height or the towing vehicle speed. Try raising the cutting height and driving slower when cutting.
  • B
    Bethany MannNov 13, 2025
    Why won't my DR PRO-XL 44T Lawn Mower engine start?
    • V
      vincentmerrittNov 13, 2025
      If your DR Lawn Mower engine won't start, several issues could be the cause. First, make sure that the Blade Control Switch is in the DOWN Disengaged position and that the Spark Plug wire is attached. For a cold engine, ensure the Throttle is in the CHOKE position. The gas must be fresh and clean. Old gas should be replaced. Dirty or cracked Spark Plugs should be replaced. If the Spark Plug is oily, remove it, cover the plug hole with a rag, and crank the engine to clear oil from the cylinder, then clean and reinsert the plug. Check the air filter and replace if needed, following the Engine Owner’s Manual. Also, inspect the fuses in the wiring harness and replace them if necessary. Check all wire connections, especially the ground connection (the large green wire from the Battery to the En...

Summary

Chapter 1: General Safety Rules

Labels

Safety and information labels on the mower for proper use and identification.

Protecting Yourself and Those around You

Essential personal safety precautions for operating the mower.

Safety with Gasoline - Powered Machines

Critical safety guidelines for handling gasoline and fuel systems.

Slope Operation

Precautions and guidelines for operating the mower on slopes.

General Safety and User Notes

Important safety rules and operational notes for users.

Chapter 2: Setting Up the DR TOW-BEHIND FIELD and BRUSH MOWER

DR TOW-BEHIND FIELD and BRUSH MOWER Controls and Features (Pro and Pro-XL Models)

DR TOW-BEHIND FIELD and BRUSH MOWER Controls and Features (Premier Model)

Chapter 3: Operating the DR TOW-BEHIND FIELD and BRUSH MOWER

Clutch Break-in (Burnishing)

Procedure to burnish the clutch for optimal performance and longevity.

Before Starting the Engine

Adjusting the Mower Deck Height

Offset Mowing

Techniques and procedures for offset mowing.

Changing the Tow Bar Offset Direction

Slopes and Uneven Terrain

Safety and operational advice for mowing on slopes and uneven ground.

Chapter 4: Maintaining the DR TOW-BEHIND FIELD and BRUSH MOWER

Regular Maintenance Checklist

A checklist for regular maintenance tasks to ensure optimal performance.

Lubrication Procedures

Engine Oil and Filter Maintenance

Drive Belt Maintenance

Swinging Blade Maintenance

Chapter 5: Troubleshooting

Troubleshooting Common Issues

A table of common symptoms, causes, and solutions for troubleshooting.

DR PRO-XL 44T Specifications

General IconGeneral
Cutting Width44 inches
TransmissionHydrostatic
Engine Type4-cycle
Cutting Height1.5" - 4.5"
Drive SystemRear-wheel drive
EngineBriggs & Stratton OHV

Related product manuals