CONTACT US AT www.DRpower.com 13
4. For Machines with Dual Wheels only: Slide a Wheel onto the Axle with the
Valve Stem facing in and install a Washer against the Wheel (Figure 10).
Note: No Washers are needed against the Axle Brackets. Dual Wheel machines use
one washer between the Dual Wheels and one on the outside. Single Wheel
machines only use one Washer on the outside.
5. For all Machines: Install a Wheel (second wheel for Dual Wheel models)
with the Valve Stem facing out and place a Washer against the Wheel
(Figure 11).
6. Secure the Wheel/s onto the Axle with a Cotter Pin. Use Pliers to bend the
ends of the Cotter Pin to secure the Wheels.
7. Repeat for the Wheel/s on the opposite side.
8. Tighten axle bracket hardware.
9. Tip the Cart over onto the Wheels.
Installing the First Gas Spring
1. Tilt the Cart Bed up by pulling the Lift Handle out and lifting up on the
front of the Cart (Figure 12).
Note: In the next step, the Gas Spring needs to be installed with the larger end
attached to the Frame and the thin Shaft end to the Cart Bed.
2. Insert the right side Gas Spring onto the Studs by pressing the holes in
the ends of the Gas Spring over the Studs. They will snap into place.
(Figure 13).
3. Before installing the second gas spring, the foot assist will need to be
installed (Figure 4, item 8) *(PRO MODELS ONLY). Leave the Cart in the
up position for the following procedure. (PREMIER models skip to step 7)
4. Remove the two 5/16-18 nuts using a 1/2" wrench while keeping a finger
on the head of the carriage bolt inside the bed so it does not rotate.
5. Drop two Carriage bolts, 5/16-18 X 1.75″, Item 11 found in the product
pack (Figure 3) into the open square holes directly to the right of the area
where the nuts were just removed.
6. Fit the foot assist up to the carriage bolts as shown in Figure 15 and
secure using a 1/2" wrench and the two 5/16-18 flange nuts previously
removed, and two additional 5/16-18 flange nuts, item 12 found in the
product pack (Figure 3). Make sure to keep a finger on the head of the
carriage bolts inside the bed when tightening.
7. The 2
nd
gas spring will be installed once the collector is completely
assembled, page 24.
To Next Page
Loading...
Need help?
General