User Manual for LoRaWAN End Nodes - LA66 USB LoRaWAN Adapter User Manual
1.10 Upgrade Firmware of LA66 USB LoRaWAN Adapter
TheLA66 USB LoRaWAN Adapter is the same as the LA66 LoRaWAN Shield update method.
Just use the yellow jumper cap to short the BOOT corner and the RX corner, and then press the RESET button
(without the jumper cap, you can directly short the BOOT corner and the RX corner with a wire to achieve the same
effect).
Notice: If upgrade via USB hub is not sucessful. try to connect to PC directly.
Page 28 / 30 - last modified by Xiaoling on 2022/12/29 09:45
To Next Page
Loading...