Dragon Touch Vision 3 Pro - Getting Started; Overview of Modes

GETTING STARTED
Welcome to your new Vision 3 Pro. To capture video and photos, you need a microSD
card (sold separately).
MICROSD CARDS
Use brand name memory cards that meet these requirements:
• MicroSD, MicroSDHC, or MicroSDXC
• Class 10 or UHS-I rating
• Capacity up to 64GB (FAT32)
Note:
1. Please format the microSD card first in this camera before using. To keep your microSD
card in good condition, reformat it on a regular basis. Reformatting erases all of your
content, so be sure to offload your photos and videos first.
2. FAT32 format microSD card stops recording when the storage of each file is over 4GB
and starts to record again on a new file.
POWERING ON + OFF
To Power On:
Press and hold the Mode button for three seconds. The camera beeps while the camera
status light is on. When information appears on the LCD display or the camera status
screen, your camera is on.
To Power Off:
Press and hold the Mode button for three seconds. The camera beeps while the camera
status light is off.
SWITCHING MODE:
To Switch Mode:
Turn on camera, press Mode button to switch mode.
To Exit Mode:
Press the Mode button to exit mode.
TURNING ON / OFF Wi-Fi
To turn on Wi-Fi:
Turn on camera, press UP Button to turn on Wi-Fi. You can also find WIFI settingfromthe
pull-downmenu in the screen.
To turn off Wi-Fi:
Press Up button to turn off Wi-Fi.
Note: Camera does not record sound when it is in the waterproof case.
There are 8 modes: Video, Loop Recording, Time Lapse Video, Slow Motion Video,
Photo, Self-timer, Continuous Lapse and Burst Photo.
VERVIEW OF MODES
Mode
Video Loop TimeLapse Photo
SlowMotionBurstPhotoContinuousSelf-timer
00:02:15 29.1G
4K 30FPS
Video
Tap here
05 06