Step 15: Using a 4mm Allen wrench loosen 3
retaining bolts on latch and adjust to match
alignment with striker pin. (See Figure O)
Step 16: Install supplied rubber bump stop at
bottom corner of plastics in line with door
frame. (See Figure P)
Step 17: Before tightening all hinge hardware,
shut door to ensure that door frame aligns
with plastics. Once preferred alignment has
been reached tighten all hinge hardware.
(See Figure Q)
*Note: Door skin was removed for instructional photos.
For further assistance contact your authorized DragonFire Dealer
Dragonfire Racing
To Previous Page
Loading...