Need help?Do you have a question about the Draper 3004A and is the answer not in the manual?
General| Brand | Draper |
|---|---|
| Model | 3004A |
| Category | Power Tool |
| Language | English |
Never use the torque wrench to undo fasteners as this will damage the ratchet and calibrated setting.
Return the torque wrench if ratchet, handle lock, or audible click fails, or if out of calibration.
Torque wrenches in this leaflet are for right-hand torquing only and not for left-hand threads.
Advice on general use, calibration for critical measurements, and alternative Draper tools.
Steps to unlock, set, and lock the torque wrench handle for adjustment.
Ensure the torque wrench is adjusted to the lowest torque setting when not in use.
Instructions on applying steady pull and indicators (audible click, touch, visual) of reaching set torque.
Warnings against over-pulling, improper use, and advice on maintenance and storage.
Guidance on cleaning, repair restrictions, and the importance of a re-calibration schedule.
Example of setting a 3/8" drive torque wrench to 36Nm using scale indicators.
Example of setting a 3/8" drive torque wrench to 318.8 in-lb using scale indicators.
Example of setting a 1/2" drive torque wrench to 96Nm using scale indicators.
Example of setting a 1/2" drive torque wrench to 70.84 ft-lb using scale indicators.
Example of setting a 3/4" drive torque wrench to 180Nm using scale indicators.
Example of setting a 3/4" drive torque wrench to 132.8 ft-lb using scale indicators.
To Next Page
