Draytek Vigor 2862 Series User Manual

8
3
3
.
.
H
H
a
a
r
r
d
d
w
w
a
a
r
r
e
e
I
I
n
n
s
s
t
t
a
a
l
l
l
l
a
a
t
t
i
i
o
o
n
n
This section will guide you to install the router through hardware connection.
3
3
.
.
1
1
N
N
e
e
t
t
w
w
o
o
r
r
k
k
C
C
o
o
n
n
n
n
e
e
c
c
t
t
i
i
o
o
n
n
1. Connect the DSL interface to the land line jack with a DSL line cable, or
Connect the cable Modem/DSL Modem/Media Converter to the WAN port of router
with Ethernet cable (RJ-45).
2. Connect one end of an Ethernet cable (RJ-45) to one of the LAN ports of the router
and the other end of the cable (RJ-45) into the Ethernet port on your computer.
3. Connect one end of the power adapter to the router’s power port on the rear panel,
and the other side into a wall outlet.
4. Power on the device by pressing down the power switch on the rear panel.
5. The system starts to initiate. After completing the system test, the ACT LED will light
up and start blinking.

Draytek Vigor 2862 Series Specifications

General

Firewall Type	Stateful Packet Inspection (SPI)
VPN Passthrough	Yes
DoS Protection	Yes
Concurrent VPN Tunnels	50
LAN Interfaces	4 x Gigabit Ethernet
USB Ports	2 x USB 2.0
VPN Throughput	200 Mbps
Firewall Features	SPI, DoS/DDoS protection
VPN Protocols	IPSec, PPTP, L2TP
Routing Protocols	Static Routing, RIP v1/v2, OSPF
Security Features	Firewall, VPN, Content Filtering, DoS Protection
Management	Web Interface, CLI, SNMP
Dimensions	241mm x 165mm x 44mm
Power Supply	12V DC
Content Filtering	Yes, by URL keyword, category, and application