EasyManuals Logo

Draytek Vigor 2862 Series User Manual

Draytek Vigor 2862 Series
18 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
V
V
i
i
g
g
o
o
r
r
2
2
8
8
6
6
2
2
L
L
a
a
c
c
LED
Status
Explan
ation
ACT (Activity)
Off
The router is powered off.
B
linking
The router is powered on and run
ning
normall
y.
WAN2
On
Internet connection is ready.
Off
Internet co
nnection is not ready.
B
linking
The data is transmitting.
QoS
On
The
QoS function is
active.
Off
The QoS
function
is inactive.
LTE
On
LTE device
i
s connected and ready for use.
Off LTE device is not detected, or has serious
problem (e.g., no SIM card, SIM pin error, SIM
deactivated, and etc.).
Blinking Slowly: LTE device is in dialing up.
Quickly: The data is transmitting.
DSL On The router is ready to access Internet through DSL
link.
Blinking Slowly: The DSL connection is ready.
Quickly: The
connection is training.
WCF On The Web Content Filter is active. (It is enabled
from
F
irewall >>
General Setup
)
.
Off
WCF is disabled.
USB
On
USB device is connected and ready for u
se.
Off
No USB device is connected.
B
linking
The data is transmitti
ng.
2.4G
5G
On
Wireless access point is ready
Off
Wirele
ss function is disabled.
Blinking
It will blink slowly while wireless traffic goes
through.
ACT and WLAN LEDs blink quickly and
simultaneously when WPS is working, and will
return to normal condition after two minutes.
(You need to setup WPS within 2 min
utes.)
B
linking
The data is transmitting.
LED on Connector
LAN P1~P4
P5/WAN2
Left
LED
On
The port is connected
.
Off
The
port is disconnected.
Blinking
The data is transmitting.
Right
LED
On
The port is connected with 1000Mbps.
Off
The port is connected with 10/100Mbps
The port “P5/WAN2” is switchable. It can be used for LAN connection or WAN connection
according to the settings configured in WUI.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Draytek Vigor 2862 Series and is the answer not in the manual?

Draytek Vigor 2862 Series Specifications

General IconGeneral
Firewall TypeStateful Packet Inspection (SPI)
VPN PassthroughYes
DoS ProtectionYes
Concurrent VPN Tunnels50
LAN Interfaces4 x Gigabit Ethernet
USB Ports2 x USB 2.0
VPN Throughput200 Mbps
Firewall FeaturesSPI, DoS/DDoS protection
VPN ProtocolsIPSec, PPTP, L2TP
Routing ProtocolsStatic Routing, RIP v1/v2, OSPF
Security FeaturesFirewall, VPN, Content Filtering, DoS Protection
ManagementWeb Interface, CLI, SNMP
Dimensions241mm x 165mm x 44mm
Power Supply12V DC
Content FilteringYes, by URL keyword, category, and application

Related product manuals