Draytek Vigor167 Quick Start Guide

5
4
4
.
.
S
S
o
o
f
f
t
t
w
w
a
a
r
r
e
e
C
C
o
o
n
n
f
f
i
i
g
g
u
u
r
r
a
a
t
t
i
i
o
o
n
n
To use the Vigor 167 as your DSL modem with a router or PC, simply connect the
modem to the VDSL or ADSL line and connect your router / PC to the Vigor 167’s
LAN port.
The Vigor 167 is a full-bridge modem, which will bridge ADSL and VDSL
connections out of the box. Just configure the PPPoE or DHCP connection on your
router / PC. Verify your router or PC is connected by checking the LAN P1 and P2
LEDs on the modem.
In its default ‘modem’ or ‘bridge’ mode, the Vigor 167 does not provide DHCP for
local management, manually configure a PC to access its web interface.
Note
Configure the IP address of the computer to be within the same
subnet. The default IP address of Vigor 167 modem is
192.168.2.1, with a subnet mask of 255.255.255.0.
For a full demonstration of how to configure an IP address
manually, see this guide:
https://www.draytek.co.uk/support/guides/kb-windows-fixedip
Open a web browser on your PC and type http://192.168.2.1. A pop-up window
will open to ask for username and password. Please type “admin/admin” as the
Username/Password and click Login.
Wait a few seconds for the web interface to load, indicated by a red line at the
top of the page.

Draytek Vigor167 Specifications

General

VDSL	Yes
Interface	RJ-45, RJ-11
Modem speed	30000 Kbit/s
Antenna type	Internal
Storage temperature (T-T)	-25 - 70 °C
Operating temperature (T-T)	0 - 45 °C
Operating relative humidity (H-H)	0 - 45 %
DC input voltage	12 V
Power consumption (typical)	4.4 W
Routing protocols	IP

Weight and Dimensions

Depth	181 mm
Width	40 mm
Height	125 mm
Weight	270 g