This will expand the WAN1 settings panel. On this screen, configure the following
settings:
ADSL Setting
• VPI: 0
• VCI: 38
VDSL2 Setting
• Service VLAN: Enabled
• Tag: 101
• Priority: 0
Click Apply to apply the setting changes. The Vigor 167 modem is now ready to
pass-through your Internet connection, to a connected PC, Router or Firewall.
On the device that you will be connecting to the Internet with, configure the
WAN for DHCP/Static IP if your ISP provides a direct connection. Otherwise,
configure a PPPoE connection on the device with the credentials supplied by your
ISP to establish an Internet connection.
To Next Page
Loading...
