Vigor2860 Series Quick Start Guide
13
1
1
.
.
1
1
.
.
6
6
F
F
o
o
r
r
V
V
i
i
g
g
o
o
r
r
2
2
8
8
6
6
0
0
V
V
a
a
c
c
LED Status Explanation
Blinking The router is powered on and running
normally.
ACT (Activity)
Off The router is powered off.
On USB device is connected and ready for use.USB
Blinking The data is transmitting.
On
Wireless access point with bandwidth of
2.4GHz/5GHz is ready.
2.4G/5G
Blinking
It will blink slowly while wireless traffic
goes through.
ACT and WLAN LEDs blink quickly and
simultaneously when WPS is working, and
will return to normal condition after two
minutes. (You need to setup WPS within 2
minutes.)
On Internet connection is ready.
Off Internet connection is not ready.
WAN2
Blinking The data is transmitting.
On The router is ready to access Internet
through DSL link.
DSL
Blinking Slowly: The DSL connection is ready.
Quickly: The connection is training.
On A PSTN phone call comes (in and out).
However, when the phone call is
disconnected, the LED will be off.
Line
Off There is no PSTN phone call.
On The phone connected to this port is
off-hook.
Off The phone connected to this port is
on-hook.
Phone (1-2)
Blinking A phone call comes.
LED on Connector
On The port is connected.
WAN2
Left
LED
Off The port is disconnected.
To Next Page
Loading...
Need help?
General
