18 19
ENEN
Replace the Dust Collection Bag
Routine Maintenance
According to the status indicator (blinking orange) and app prompts, replace it with a new one when the dust collection bag is full. It is recommended to replace
the bag every 6-8 weeks.
1. Discard the dust collection bag 3. Install a new dust collection bag
2. Clean the lter
4. Close the upper cover of auto-empty baseNote: When taking out the dust collection bag, close the dust bag handle to
avoid dust leaking out.
Note:
• Install the lter in place after cleaning to prevent dust from falling into the air duct.
• Rinse the lter with water until it is clean. Thoroughly dry the lter before re-installing.
Note: Do not close the base forcelly, if the upper cover of base cannot be
closed and the dust collection bag is not installed.
Clean the Air Duct
Robot Restarting
Battery
Routine Maintenance
If the air duct is blocked, please clean it according to the following steps.
If the robot stops responding or cannot be turned o, press and hold down
the button
for 10 seconds to forcefully turn it o. Then press and hold the
button
for 3 seconds to turn the robot on.
The robot contains a high-performance lithium-ion battery pack. Please
ensure that it remains well-charged for daily use to maintain optimal
battery performance. If the robot is not used for an extended period of
time, turn it o and put it away. To prevent damage from over-discharging,
the robot should be recharged at least once every three months.
1. Unscrew mounting screws on the air duct cover and remove the cover plate.
2. Check whether the air duct is blocked by foreign objects. If any, clean them.
3. Reinstall the air duct cover as shown in the diagram.
To Next Page
Loading...
Need help?
General
