the robot onto the base station, the robot should turn on automatically and begin charging. To turn off the robot,
move the robot away from the base station and press and hold the button for 3 seconds.
Fast Mapping
After configuring the network for the first time, follow the instructions in the app to quickly create a map. The robot
will start mapping without cleaning. When the robot returns to the base station, the mapping process has been
completed and the map will be saved automatically.
Pause/Sleep
When the robot is running, press any button to pause it.
If the robot is paused for more than 10 minutes, it automatically enters sleep mode. All indicators on the robot will
turn off. Press any button on the robot or base station, or use the app to wake up the robot.
Note
The robot will turn off automatically if it is left in the sleep mode for more than 12 hours.
If the robot is paused and placed onto the base station, the current cleaning process will end.
Auto Resume Cleaning
If the battery is too low, the robot will automatically return to the base station to charge. After charging to the
appropriate battery level, it will resume unfinished cleaning tasks.
Note: To use this function, please open it in the App.
Do Not Disturb (DND) Mode
When the robot is set to Do Not Disturb (DND) mode, the robot will be prevented from resuming cleaning and the
power indicator will turn off. DND mode is disabled by default at the factory. You can use the app to enable DND
mode or modify the DND period. The DND period is 22:00–8:00 by default.
Note
The scheduled cleaning tasks will be performed as usual during the DND period.
The robot will resume cleanup where it left off after the DND period expires.
Spot Cleaning
When the robot is on standby, press briefly the button to enable the spot cleaning mode. In this mode, the robot
cleans a square-shaped area of 1.5 × 1.5 meters around it and returns to its starting point once the spot cleaning is
completed.
Robot Restarting
If the robot stops responding or cannot be turned off, press and hold the button for 10 seconds to forcefully turn it
off. Then, press and hold the button for 3 seconds to turn the robot on.
How to Use
Vacuum and Mop
Note: When using the mop assembly for the first time, the robot performs the “Vacuum and Mop” task by default.
1. Start cleaning
Press the button on the base station or on the robot, or use the app to make the robot start from the
base station. Then the robot will plan the optimal cleaning route and perform the cleaning task based on the
created map.
To Next Page
Loading...
Need help?
General
