Dreame V10 User Manual

2. Rinse the cyclone assembly with water until it is clean. To thoroughly dry the
cyclone assembly, keep it in a ventilated or cool place for at least 24 hours. Caution:
Do not clean the cyclone assembly in a dishwasher or washing machine, and do not
attempt to dry it in a tumble dryer, oven, microwave, or near an open fire.
3. Once it is dry, reinstall the cyclone assembly.
1
2
1. Rotate the cyclone assembly in the direction illustrated to unlock it, then remove
the cyclone assembly.
Care & Maintenance
Cleaning the Cyclone Assembly
1. Place the vacuum securely on a flat surface, then turn the HEPA filter assembly
cover in the direction indicated and remove the HEPA filter assembly.
Note: Remove the built-in foam pad before cleaning the HEPA filter assembly. Rinse
the HEPA filter and foam pad with water.
Care & Maintenance
Cleaning the HEPA Filter Assembly
2. Rinse the HEPA filter and foam pad with water. To thoroughly remove all dust
caught in the filter, rotate the HEPA filter by 360 degrees while rinsing. Lightly tap the
filter against a sink several times to remove any excess debris.Keep the HEPA filter in
a well-ventilated and cool place to fully dry.
Note: Fully dry the filter (at least 24 hours) before reinstalling it.
1
3
12
6
111
57
210
48
39
24 hrs
12
6
111
57
210
48
39
24 hrs
11 12

Dreame V10 Specifications

General

Noise Level	72 dB
Motor Power	450 W
Power	450 W
Suction Modes	Turbo
Dust Collection Type	Dustbin