Dreame V10 User Manual

12
6
111
57
210
48
39
24 hrs
1. Push the brushbar head release button in the direction of the arrow until the cover
of the brushbar head pops to open, then remove the brushbar head by lifting it in the
direction indicated.
2. After you have finished cleaning the Soft Roller Nozzle , reinstall it by following the
disassembly steps in reverse.
Cleaning the Soft Roller Nozzle
Note: To prevent injury from accidentally turning on the vacuum, make sure the Soft
Roller Nozzle or Mini-Motorized Nozzle is detached from the vacuum before
removing the head. The Mini-Motorized Nozzle and Soft Roller Nozzle contain
electrical components, and the Soft Roller Nozzle head also contains bearings. Do
not wash these parts with water. Be careful of sharp objects when removing debris
caught in the heads of Soft Roller Nozzle and Mini-Motorized Nozzle.
Care & Maintenance
Cleaning the Soft Roller Nozzle and
Mini-Motorized Nozzle
Care & Maintenance
Cleaning the Mini-Motorized Nozzle
1. Use a coin as illustrated to rotate the
lock counterclockwise until you hear a
click.
2. After unlocking the brush head,
remove it from the Mini-Motorized
Nozzle , then rinse and clean the brush
head.
3. Stand the brush head upright in a
well-ventilated area for at least 24 hours
until it is fully dry.
4. Once the Mini-Motorized Nozzle is dry,
reinstall it by following the disassembly
steps in reverse.
13 14

Dreame V10 Specifications

General

Noise Level	72 dB
Motor Power	450 W
Power	450 W
Suction Modes	Turbo
Dust Collection Type	Dustbin