16
EN
Care & Maintenance
Cleaning the Cyclone Assembly
1. Rotate the cyclone assembly in the direction as illustrated to unlock it, then remove the
cyclone assembly.
Note: Use the 2-in-1 brush nozzle to remove cyclone separator from the housing. Turn the
nozzle in the direction as shown in the diagram for a thorough cleaning.
2. Rinse the cyclone assembly with water until it is clean. Thoroughly dry the cyclone
assembly.
Note: Keep it in a ventilated or cool place for at least 24 hours.
12
6
111
57
210
48
39
24 hrs
2
3
1
To Next Page
Loading...
