Air duct blocked
Check whether the dust cup, carbon
ber rod, and smart multi-brush bar are
blocked.
Roller brush stuck
Refer to the maintenance guide
[Cleaning the Smart Multi-Brush Bar]
section to clean the ber material and
hairs wrapped around the oller brush.
Replace the lter
Refer to the maintenance manual
[Cleaning Filter] section to remove the
lter and replace it.
Reset Filter（5 seconds）
Press and hold the button
for 5
seconds to enter the countdown to
reset the lter. Wait and until
appears
on the screen, the reset is successful.
The battery runs out Please charge as soon as possible.
Low battery capacity Please charge as soon as possible.
Battery is overheating
Please wait and continue to use after
battery temperature is normal.
Error
Please contact our after-sales service
department for maintenance.
14
EN
If you need to pay attention to any abnormality during the use of the product, a prompt
will be shown on the screen. You should follow the instructions on the screen to keep the
performance normal.
How to Use
To Next Page
Loading...
