16
Care & Maintenance
3. Remove the pre-lter rst, then lift the handle of the cyclone assembly and turn it
counterclockwise until it stops, then pull to lift out the cyclone assembly.
Note: It is recommended to clean the pre-lter at least once every 3 months and the
cyclone system at least once every 6 months.
1
2
3
Pre-FilterCyclone Assembly
4. Wipe the dust cup with a soft wet cloth. Pay attention to wring out the discloth before
using.
5. Rinse the cyclone assembly and pre-lter until they are clean. After washing, air dry for
at least 24 hours .
12
6
111
57
210
48
39
24 hrs
To reduce the risk
of electric shock, do
not rinse the dust
cup with water.
EN
To Next Page
Loading...
Need help?
General
