22
11. RECORDING
11.1 Recording guide
USB memory
To record programs a storage device (USB Memory 2.0) must be connected formatted in FAT32, EXT2,
EXT3. To format an USB memory larger than 32GB with your windows PC in FAT32, download the
Fat32Formatter program from the internet to your PC.
To record HD programs the USB memory must have a minimum writing speed of 20 Mbps. It is
recommended to record HD channels to a USB hard disk. It is only possible to record to one connected
storage device. Select the Storage device to record in Multimedia (User menu).
NOTE Ensure that there is enough free memory before recording. The recording will
not start, if there is not enough free memory. Do not disconnect the USB memory from
the receiver during recording or playback as this could cause damage to the receiver
and/or USB memory. Highly fragmented or used memory may also not operate
properly. Recording to an Storage device formatted in NTFS is not possible.
USB Eject
Press the key to eject all connected USB memories. Always use this option before
disconnecting an USB memory. This function allows you to safely remove an USB memory
connected to your receiver to prevent loss of data.
Multi channel Recording
You can record at the same time 3 programs or record 2 programs and timeshift one program.
Channel change
While you are recording, you can watch channels of the same frequency as the recorded
channels.
Press CH UP/DOWN keys to change channels.
Press OK key to display the channels you can change to and select a channel with the
▲
/
▼
/OK keys.
Stand-by
Press STAND-BY key during a recording to switch the receiver to Stand-by mode after the
recording is finished. For timer recordings, the receiver will switch to operation mode and start
recording at the specific time. After the recording is finished, the receiver will switch back to
Standby mode (after 1 minute).
Timer 20 Timer events (recordings and reservations) can be programmed.
TV/Radio Record TV and radio programs.
Playback Enter Recordings (Multi media) to playback recordings.
11.2 Instant recording
Recording Press RECORDING key to start the recording.
Recording list Press EXIT, STOP or INFO keys to display the recording list.
The duration as set in Multimedia (User menu) is displayed.
To Next Page