Dremel 1671 - Page 6

Adj
stments
r
SETII NG THE TABLE FO R
HORIZONTAL
OR BEVEL cun G
1. Loo sen the tabl l ad
tilte d to the left an
degree h
orizorta -
for bevel CU " 9 F
2. A degree ~- ..
as a c'" ::
Ima epa 9 e r be al c • og 0 grea "'r
pre ISI- IS required, make practice c ts a d adJus'
e 'able as necessary f r your requlrerne ts
3. OTE: When cutt ing at extr eme ngle s. he drop
foot should be lifted off the wo rk piece, as It will
imped e cut tin g. Hold the work piece ag ai nst the
table. The
dr op foot may be disassembled when
t hick materi als are cut at extreme angles.
ALIGNING THE DEGR EE SCALE POINTER
1. Loosen the table lock knob a nd move the ta ble u nt i I it
is
approximately perpend icular, or at a right angle to
the blade.
2. Place asmall square on the table next to the bla e as
shown in (Fig. 3) to check if the table is 90 degrees
to th e blade. If adju st me nt is needed, raise or lower
the table u ntil table is appr oximately 90 deg rees "0
the blade and sec ur el y tig hten the table lock nob.
3. Loosen the s crew holding the degree scale pomte r
as
shown in (Fig. 3), move pointer to the 0 degrfO> e
mark and securely tighten screw . Remem ber t e
degree scale is a convenient gu ide but shou ld no be
relied upon for precision, Make p ra ctice uts .
scrap wood to dete rm ine if your a ng le settings are
correct.
ADJUSTMENT
SCREW
POINTER
POINTER
P
age6