Dremel 1671 - Mounting Scroll Saw to Bench

Moun ing the scroll saw to a bench
.
1. W h n mounting this saw to a wo rkb ench, a solid
4.
Ex a mp le of mounting this S ro
bench is pref
err ed over a pl yw ood bench whe re
noise and vi br ation w ill be more not ic able.
2. Ha r dwar e to mount this saw to a workbench is NOT
SUPPLIED
wi th the saw. However, we rec o mm en
SCROLL S
~ ASE
the hardware used be no sma
ll r than the fo ll owmg.
Quantity Description
4 H H ead Screws, 1/ 4-20 Length R eq uired
4 Flat Washers, 9/32 1.0 .
4
Lockwasher, 9/32 1.0.
a H ex Nut s. 1/ -20
3. S ft foam pad to place be tween your scroll saw and
workbe nch is NOT s upp lied wi th the saw. However
we highly recommend the use of such a pad
('
redu ce nO ise and Vib ration.
Quantity Description
1 Soft foam pad, uch as ca rpet padding,
24" x 1 2" x 1 12'
Do NOT overtighten mo unting bolts -leave some cus hlo
in the foam pad f r absorbing nO i se and vibration.
WARNING: Always remove the plug from power source
be fore making an y adjustments on your saw.
ATIENTION . Whe n in se rting the front right h ex head
screw, it
will be n ec essary to remove 5 screws and
re mov the fan box cover.
WORKBENCH •
5. If you prefer to mount your saw to a leg set we
AlT C I G THE MAGNIFIER LAMP
re comm end t he leg set for bench top tools whi ch is TO YOU SCROll SAW (Available as Accessory)
available th rough Dr em e !. The n umber of this leg sert rou nd end of lamp base into the
s
et is 164 35. Th iS leg set is an optional acce ssor y e rear of saw as shown in (Fig. 12 ).
an i ns truc tions to mou nt the scroll saw to this leg
. w ays be sure to pos
it ion the cord
set are
inclu d ed in the leg set package.
ay
rrom cL Jlt i n area.
'iN"
li(40
Page 9