Dremel 400 Series XPR User Manual

12
SPEED SETTINGS (CONTINUED)
Catalog
Number
516, 517, 518,
500
Soft Hard Laminates Steel Aluminum, Shell Ceramic Glass
Wood Wood Plastic Brass, etc. Stone
4-6 4-6 - 8 6 - - -
4-6 4-6 - 8 6 - - -
Abrasive Points
Catalog
Number
903, 911, 921,
932,941, 945,
952, 953, 954,
971, 997,
8153, 8175,
8193, 8215
541
Soft Hard Laminates Steel Aluminum, Shell Ceramic Glass
Wood Wood Plastic Brass, etc. Stone
10 10 - 8 4 6 10 -
10 10 - 8 4 610 -
Aluminum Oxide Grinding Stones
Catalog
Number
453, 454, 455
Soft Hard Laminates Steel Aluminum, Shell Ceramic Glass
Wood Wood Plastic Brass, etc. Stone
-- - 8 - -- -
Chain Saw Sharpening Stones
Use only Dremel™ tested, high performance accessories.
* Speed for light cuts; Caution - burning on deep grooves.
• Depending on cutting direction relative to grain.
Catalog
Number
612, 640
615, 617, 618,
650, 652
654
Soft Hard Laminates Steel Aluminum, Shell Ceramic Glass
Wood Wood Plastic Brass, etc. Stone
10* 8• - - - - - -
10* 8• - - - - - -
10* 8• - - - - - -
High Speed Router Bits
Catalog
Number
83142, 83322,
83702, 84922,
85422, 85602,
85622
Soft Hard Laminates Steel Aluminum, Shell Ceramic Glass
Wood Wood Plastic Brass, etc. Stone
- - 6 10 4 6 10 10
Silicon Carbide Grinding Stones

Dremel 400 Series XPR Specifications

General

Speed Range	5, 000 - 35, 000 RPM
Voltage	120V
Power Source	Corded Electric
Collet Size	1/8 inch
No Load Speed	5, 000 - 35, 000 RPM
Warranty	2 years
Cord Length	6 ft
Length	9 inches