Dremel 400 Series XPR User Manual

5
GETTING TO KNOW YOUR ROTARY TOOL
Shaft Lock Button
On/Off Switch
Collet Wrench
Collet Nut
Collet
Brush Cover
(one each side)
Housing Cap
Ventilation Openings
Hanger
Power Cord
Variable Speed Dial
Unpacking & Checking Contents
To avoid injury from unex-
pected starting or electri-
cal shock, always remove plug from wall
outlet when tool is not in use.
Separate all loose parts from packing materi-
als and check each item with the contents
listed on the carton to make sure all items are
accounted for before discarding any packing
material.
Description
The 400 Series XPR™ Rotary Tool incorpo-
rates both high-speed and performance to
serve as a carver
, grinder, polisher, sander,
cutter, power brush, drill, and more.
The tool utilizes a small, but effective DC
motor. The large variety of available
Dremel™ accessories includes abrasive
wheels, drill bits, wire and nylon brushes,
engraving and carving cutters, router bits,
polishing points and more. The ability to add
different Dremel™ attachments adds to the
multi-faceted uses of the tool. The variety of
projects you can do with the tool is limitless.
The 400 Series XPR Rotary Tool is a high-
speed tool and operates at speeds 5,000 to
35,000 RPM. (A typical electric drill operates
only up to 2500 RPM!). When used with
Dremel™ accessories and attachments, the
400 Series XPR rotary tool’s high speed per-
formance allows you to work on even the
most demanding projects without having to
exert undue pressure on the tool. The tool
does the work for you.
WARNING
!
IMPORTANT! If any parts are missing, or if
you require any assistance with these
instructions, please contact the Dremel™
Consumer Service at:
1-800-437-3635
or check our website at www.Dremel.com.

Dremel 400 Series XPR Specifications

General

Speed Range	5, 000 - 35, 000 RPM
Voltage	120V
Power Source	Corded Electric
Collet Size	1/8 inch
No Load Speed	5, 000 - 35, 000 RPM
Warranty	2 years
Cord Length	6 ft
Length	9 inches