Dremel 670 - Page 12

2 = Coupling
3 = Rip Crosscut Blade
4 = Screw
Maximum Capacities:



ASSEMBLY
MINI SAW ATTACHMENT INSTALLATION




6
 
 
 
If the collet nut and collet are not removed from the motor shaft, the tool will
not function properly.
 7
!
TO PREVENT DAMAGE TO TOOL, DO NOT OVER TIGHTEN
DRIVE ADAPTER. TIGHTEN THE DRIVE ADAPTER FINGER

WRENCH. 
 

oriented on your rotary tool so that the speed control switch on the tool
8
12