of the blade, but not in line with the blade. Kickback could cause the
saw to jump backwards, but kickback forces can be controlled by the
operator, if proper precautions are taken.
b.
until the blade comes to a complete stop. Never attempt to remove
the saw from the work or pull the saw backward while the blade
is in motion or kickback may occur. Investigate and take corrective
actions to eliminate the cause of blade binding.
c.
If
a saw blade binds, it may walk up or kickback from the workpiece as
the saw is restarted.
d.
kickback. Large panels tend to sag under their own weight. Supports
must be placed under the panel on both sides, near the line of cut and
near the edge of the panel.
e. Unsharpened or improperly set
blades produce narrow kerf causing excessive friction, blade binding
and kickback.
f.
If blade adjustment shifts while cutting,
it may cause binding and kickback.
areas. The protruding blade may cut objects that can cause kickback.
SAFETY INSTRUCTIONS FOR SAWS WITH PENDULUM
GUARD AND SAWS WITH TOW GUARD
LOWER GUARD FUNCTION
a.
be bent. Raise the lower guard with the retracting handle and make
sure it moves freely and does not touch the blade or any other part, in
all angles and depths of cut.
b.
9
To Next Page
Loading...
