34
Structured Tungsten
Carbide Carving Bits
Fast cutting, needle-sharp
teeth for greater material
removal with minimum load-
ing. Use on fiberglass, wood,
plastic, epoxy and rubber.
1/8" shank.
Silicon Carbide Grinding
Stones (blue/green)
Tougher than aluminum oxide
points, these are made es -
pecially for use on hard mate-
rials such as glass and ce -
ramics. Typical uses might be
the removal of stilt marks and
excess glaze on ceramics and
engraving on glass. 1/8"
shank.
Diamond Wheel Points
Excellent for fine detail work
on wood, jade, ceramic, glass
and other hard material. Bits
are covered with diamond
particles. 1/8" shanks. (Not
recommended for drilling)
Wire Brushes
Three different shapes of
wire brushes are available.
For best results wire brush-
es should be used at speeds
not greater than 15,000
RPM. Refer to Operating
Speeds section for proper
tool speed setting. The three
shapes come in three differ-
ent materials: stainless steel,
brass and carbon wire. The
stainless steel perform well
on pewter, aluminum, stain-
less steel, and other metals,
without leaving "after-rust".
Brass brushes are non spark-
ing, and softer than steel;
making them good for use on
soft metal like gold, cooper
and brass. The carbon wire
brushes are good for general
purpose cleaning.
Polishing Accessories
These include an impregnat-
ed polishing point and an
impregnated polishing wheel
for bringing metal sur faces to
smooth finish; a felt polishing
tip and felt polish ing wheel,
and cloth polishing wheel, all
1605A000DGAB 02-21 7350_7300-PGT 6/2/21 9:21 AM Page 34
To Next Page
Loading...
