23
B9>49>7.855<
Use for deburring, removing rust, and general
purpose grinding. Use with Mandrel #402.
EDD9>7.855<C
These thin discs of emery or fiberglass are
used for slicing, cutting off and similar
operations. Use them for cutting off frozen bolt
heads and nuts, or to reslot a screw head
which has become so damaged that the
screwdriver won’t work in it. Fine for cutting
BX cable, small rods, tubing, cable and cutting
rectangular holes in sheet metal.
BIG1<<EDD9>79D
Gives you fast, clean cuts in drywall. Use with
Dremel No 565/566 Cutting Guide attachment.
+9<5EDD9>79D
Cuts ceramic wall tile, cement board, and
plaster. Use with Dremel No 565/566 Cutting
Guide attachment.
*@9B1<EDD9>79D
Cuts through all types of wood and wood
composites. Use with Dremel No 565/566
Cutting Guide attachment.
978*@554)?ED5B9DC
For routing, inlaying, and mortising in wood
and other soft materials. Use with Dremel No.
335 Router attachment and No. 231
Shaper/Router table.
B14'?9>DB9<<9DC
Titanium coated brad points stay on center
and begin drilling immediately. For use on
wood. Size 1/8”, 5/32”, 3/16”, ¼” . 1/8” shank.
**B9<<9DC
HSS drill bit for use in metal and plastic. Size
1/8”, 7/64”, 3/32”, 5/64”, 1/16”, 3/64”, 1/32”.
Shank size matches the drill bit size. Different
collet size (481, 482, 483) or Dremel chuck
(4486) required according to drill bit being
used.
<1CCB9<<9DC
Diamond tipped drill bits for use on glass and
ceramic wall tile. Lubricant included.
?<<5D1>
Blows dust away for greater visibility to work
piece. Great for sanding, engraving and
carving. Do not use dust blower to stop or
slow down the tool. Do not contact dust blower
with fingers or workpiece during use.
B5=5<8E3;
This chuck allows you to quickly and easily
change accessories on Dremel Rotary Tools
without changing collets. Accepts accessories
with 1/32” - 1/8” shank. Read instruction
manual. Insert and securely tighten the shank
of the accessory well within the jaws of the
chuck.
B5=5<335CC?B95C?>D
To Next Page
Loading...
