24
$1>4B5<%M has a small screw at its tip,
and is used with emery cutting wheels and
sanding discs. Higher speeds, usually
maximum, are best for most work, including
cutting steel. Which is shown here.
$1>4B5< %? is used with the felt
polishing tip and wheels. Thread the tip on to
the screw carefully. The felt tip must thread
down straight on the screw Mandrel, and be
turned all the way to the collar.
To replace a band on the BE=*1>45B loosen
the screw without removing it to contract the
drum then slide the old band off. Slide the new
sanding band on and then expand the drum by
tightening the screw once again.
56?B55138EC5 3853; D?
=1;5 35BD19> D81D 1<<
3?=@?>5>DC1B5 1CC5=2<54D? 1335CC?BI
C81>;1>4 D81D D85 4BE= 9C CE669395>D<I
5H@1>454D?C53EB5D8521>44EB9>7EC5 If
sanding band is loose on the drum during
operation it may “fly” off and strike you or
bystanders.
!
WARNING
)5@<139>7*3B5G$1>4B5<335CC?B95C
To Next Page
Loading...
