7
Unpacking & Checking Contents
To avoid injury from unexpected starting or
electrical shock, always remove plug from
wall outlet when tool is not in use.
Model 1830 ScrollStation is shipped complete in one carton.
Separate all “loose parts” from packing materials and check
e
ach item with the “Packing List” to make sure all items are
accounted for before discarding any packing material.
If any parts are missing, do not attempt to
operate ScrollStation, plug in the power cord
or turn the switch on until the missing parts are obtained and
are installed correctly.
WARNING
!
WARNING
!
Packing List
Item Description Qty.
A 18” ScrollStation........................................................1
B Owner’s Manual ........................................................1
C Parts Bag ..................................................................1
Blades ..............................................................................6
To remove protective coating from the table surface, moisten
a soft cloth with kerosene or WD-40 and wipe off coating. Do
not use acetone, gasoline or lacquer thinner for this purpose.
After removing protective coating, If you wish, you may apply
a coat of paste wax to the table to allow the workpiece to slide
easily across the table surface and deter rust. Wipe the table
thoroughly with a clean dry cloth.
NOTE: Hardware to mount this ScrollStation to a bench or leg
set is NOT supplied. See ASSEMBLY-MOUNTING THE
SCROLLSTATION, Page 10, for recommended hardware
size.
IMPORTANT! If you require any assistance with these
instructions, please contact the Dremel Service Department
at:
1-800-437-3635
Tools Needed
To Next Page
Loading...
