USER SETTINGS
Only menu items followed by a greater-than symbol (>) can be adjusted. If no keys are selected for 5 minutes on screens: INLET
OUTLET, GRAIN DPR (INLET-OUTLET for 230V models), the display will return to normal display mode. In all the other menu items,
the display with return to the normal display mode after 20 seconds. Items without the symbol (>) are for information only and cannot be
changed or reset.
MENU to proceed to
Press ˃ MENU SELECTION to change the setting.
→
1. JOB HRS RESET >
PWR INTERRUPT X
˃
1. JOB HR RESET 0
PWR INTERRUPT 0
Press ˃ to reset to 0.
2. INLET OUTLET
100’ 80% 115’ 30%
For information only.
Unit displays GPP if set to Fahrenheit or g/kg if set to Celsius. To change this setting, see menu item 9.
4. FILTER CLEANED
XXX HRS >
˃
Press ˃ to clear filter hours.
5. COIL CLEANED
XXX HRS >
˃
Press ˃ to clear coil hours.
MODE OFF >
˃
6. HUMIDISTAT
MODE ON >
Press ˃ to turn ON or OFF.
For maximum dehumidification, make sure
HUMIDISTAT is OFF.
SETPOINT XX% >
˃ Press ˃ to cycle through 40%–90% at 5% increments (default is 50%).
8. LANGUAGE
ENGLISH >
˃
ESPANOL >
˃
DEUTSCH >
˃
FRANCAIS >
Press ˃ to change
language options.
˃
Press ˃ to change to °F or °C.
For information only.
For information only.
12. FIRMWARE
3.XX FXXX-XXX
For information only.
(Returns to
top menu item.)
The following section available only on wireless-equipped units.
XXXXXXXXX
(Returns to
top menu item.)
AT THE END OF THE JOB
To reduce the possibility of drips when moving the
unit, follow these additional steps to ensure that all
water is removed from the unit.
NOTICE: The unit will complete the defrost cycle even if
the unit is turned off but still plugged in. If the unit is
unplugged during the defrost cycle, excessive water may
accumulate in the unit and may drip out when you move
the unit.
07-02300B F600 4 Dri-Eaz Products, Inc.
To Next Page
Loading...
