Drill Master 120 Volt Variable Speed Jigsaw

Questions and Answers

I
igrossJul 31, 2025
How to fix Drill Master Power Tool that will not start?
- M
  Mr. Ricardo SandovalJul 31, 2025
  If your Drill Master Power Tool won't start, first ensure the cord is properly plugged in. Then, check if the outlet has power. If the outlet is unpowered, turn off the tool and check the circuit breaker. If the breaker is tripped, ensure the circuit has the correct capacity for the tool and isn't overloaded. If the tool has a thermal reset breaker, turn it off, let it cool, and press the reset button. If none of these steps work, it may have internal damage or wear and require servicing by a technician.
M
Mark PattersonAug 5, 2025
Why is my Drill Master 120 Volt Variable Speed Jigsaw overheating?
- M
  Michael StevensonAug 5, 2025
  If your Drill Master Power Tool is overheating, avoid forcing it to work too fast; allow it to operate at its own pace. Check for and correct any misalignment of accessories. Ensure cutting accessories are sharp, replacing them if damaged or dull. Also, clear any blockages from the motor housing vents using compressed air while wearing ANSI-approved safety goggles and a NIOSH-approved dust mask/respirator. Finally, if you're using an extension cord, eliminate it, or use one with the correct diameter for its length and load to prevent straining the motor.
F
feliciareidAug 10, 2025
Why is my Drill Master 120 Volt Variable Speed Jigsaw Power Tool running so slow?
- K
  Karl ShawAug 10, 2025
  If your Drill Master Power Tool is operating slowly, the extension cord might be too long or have too small a diameter. Try eliminating the extension cord. If you need to use one, make sure it has the right diameter for its length and the tool's load.
W
williamsjohnAug 14, 2025
What to do if Laser Guide will not illuminate on Drill Master 120 Volt Variable Speed Jigsaw Power Tool?
- C
  carsonscottAug 14, 2025
  If the Laser Guide on your Drill Master Power Tool will not illuminate, first, ensure the laser is turned on by pressing the Laser Button. If it still doesn't illuminate, check if the laser opening is dirty or blocked, and if so, turn the laser off and clean the opening. If the laser still does not work, have a qualified service technician check the tool for internal damage.
M
Mikayla PowellAug 20, 2025
Why does the Drill Master Power Tool's performance decrease over time?
- J
  Joseph JonesAug 20, 2025
  If your Drill Master Power Tool's performance decreases over time, first check if the accessory is dull or damaged; keep cutting accessories sharp and replace them as needed. Also, the carbon brushes might be worn or damaged, in which case you should have a qualified technician replace them.
A
Anna WilliamsAug 25, 2025
What causes excessive noise in Drill Master Power Tool?
- A
  Anthony RuizAug 25, 2025
  If your Drill Master Power Tool is making excessive noise or rattling, it may have internal damage or wear, such as with the carbon brushes or bearings. In this case, have a technician service the tool.