Installing Your Drinkpod
Installing Your Drinkpod 2-10
1-1. Water should pour from faucet, and nothing should be no leaking below. If there
are leaks, tighten connections with wrench, then turn o
KS-H
faucet and proceed.
9. With your hand, unscrew and remove the compression nut from the side of
F
3/8 in. Sink Adapter Valve.
Diagram 2.3(B).9 - Unscrew Compression Bolt From Sink Adapter Valve
10. Uncoil end of 1/4 in. White PP Tubing, and thread through the small end of nut.
Diagram 2.3(B).10 - Thread Tubing Through Compression Nut
To Next Page
Loading...