www.petfountain.com
the small lip located on the narrow side of tear drop shaped stator and
pull out.
Stator
Pull-Tab
bladed propeller) which is held in place magnetically. To remove the
6) Once the motor is disassembled you
can clean the parts with warm soapy
the Drinkwell
®
Cleaning Kit “Motor
and remove any build-up. For added
disinfecting and hard water removal,
clean the motor with a white vinegar
& water solution. Strengthen the
solution by increasing the amount of
white vinegar used. Be sure to rinse
thoroughly with fresh water.
7) Once the parts are clean and dry, you can reassemble the motor for use.
a) Replace the impeller.
b) Replace the stator.
c) Replace the intake plate.
1) Remove pump from the fountain as explained in the “Fountain and
gently squeeze on either side of the intake plate and pull off. It may be
it off.
PUMP MAINTENANCE
pg. 6
To Next Page
Loading...
