www.petfountain.com
4) While holding the cone
the top of the lter housing
too tight and not moving easily, try twisting the housing back and forth
in a circular motion until it loosens up enough to remove. Lift the piece
up and set aside. Most likely, the intake tube will still be attached to the
5) Lift up the stainless steel cone and set aside for cleaning.
6) Reach in the bowl and lift up the motor, remove and set aside for
cleaning.
7) While holding underneath the sidewalls of the bowl, empty the water out
of the fountain.
8) Clean the fountain parts with warm water and soap. You can also put
the fountain in the dishwasher. IMPORTANT: do not use any abrasive
cleaning solutions, sponges, or pads that could potentially scratch the
stainless steel parts. Remove the pump before placing the fountain in the
dishwasher. DO NOT PLACE PUMP IN DISHWASHER!
9) If you have troubles reaching certain spots or hard-to-reach corners, try
using a cotton swab or purchase the Drinkwell
®
Cleaning Kit, a 3-Piece
Brush kit. To purchase a Cleaning Kit, please call 866-322-2530 or visit
www.petfountain.com.
Cleaning the pump is essential to the longevity of the fountain as well as
the cleanliness of the water. Clean the pump every two weeks.
IMPORTANT: Warranty may be voided if the pump is not cleaned regularly.
Pump
Impeller
Stator
Intake Plate
PUMP MAINTENANCE
pg. 5
To Next Page
Loading...
