To Next PageTo Next Page
Need help?Do you have a question about the Drinkwell 360 and is the answer not in the manual?
General| Capacity | 128 oz (1 gallon) |
|---|---|
| Material | Plastic |
| Flow Control | Adjustable flow control cap |
| Pet Size | All sizes |
| Power Source | Electric |
| Voltage | 120V |
| Noise Level | Low |
| Suitable for | Cats and dogs |
| Filters | Replaceable carbon filter |
| Dishwasher Safe | Yes (excluding pump) |
| Number of Streams | 5 |
Key safety guidelines for operating the appliance, including reading instructions, supervision, and proper handling.
Check cord for damage, ensure inline plug is connected before operation.
Steps for placing the pump, intake tube, and aligning the cone with the cord notch.
Instructions for removing the flow control cap, spout ring, and installing the filter into the housing.
Important instruction to rinse the filter under cool water before use to remove charcoal dust.
Steps to insert the filter housing, attach spouts, and secure the flow control cap.
Guidance on attaching plastic cord clips to manage the electrical cord and secure the cone.
Position the fountain, use a protective mat, and fill the bowl to the MIN Fill Line.
Ensure hands and cord are dry before plugging in; maintain water level to prevent pump failure.
Avoid abrasive cleaners and sponges on stainless steel parts to prevent scratches. Regular cleaning is essential.
Replace filters every two weeks; more often for multiple pets. Information on purchasing replacements.
Steps to unplug, remove caps/rings, and detach cord clips for cleaning the fountain.
Instructions for removing filter housing, cone, and pump for thorough cleaning.
Clean parts with warm water and soap. Do not place the pump in the dishwasher.
Tips for reaching difficult spots using cotton swabs or a cleaning kit.
Clean the pump every two weeks for longevity and warranty. Failure to do so may void the warranty.
Step-by-step guide to removing the intake plate, stator, and impeller from the pump.
Clean pump components with soapy water or a vinegar solution to remove buildup and hard water deposits.
Instructions for reassembling the pump by replacing the impeller, stator, and intake plate.
Steps to reinstall the pump, intake tube, and cone, ensuring correct alignment and cord routing.
Replace filter, reattach housing, spout rings, and flow control cap, then secure with cord clips.
Place the fountain, fill to MAX line, reconnect plug, and power on. Adjust flow as needed.
Use diluted bleach solution for soaking parts to disinfect and prevent mold or algae growth. Rinse thoroughly.
Address white mineral deposits from hard water by cleaning more frequently, using vinegar, or using bottled water.
Detailed explanations of each part of the Drinkwell® 360, including the bowl, cone, filter, and pump.
Avoid unattended operation, chewing hazards, and improper use. Ensure electrical safety and proper extension cord use.
Do not repair yourself, avoid wet plugs, keep outlets above water, and never yank the cord.
Allow pets time to adjust to the fountain; try different locations for optimal use.
Add ice cubes to the bowl for refreshing, ice-cold running water for pets.
One-year warranty against defects. Contact information and exclusions for damage or lack of cleaning.
