www.petfountain.com
8) Look into the cone opening and make sure
the intake tube is sticking straight up from the
Housing into the cone opening and push
Filter Housing all the way down to the rubber
gasket, the housing should easily attach to
the intake tube.
based upon your personal preference or your
pet’s. Place the chosen spout on top of Filter
Housing Lid and gently press down to secure
in place.
10) On the Filter Housing Lid, align the Flow
Press down gently and the cap will snap into
place. With the Flow Control Cap, you will be
able to easily adjust the intensity of the water
right to increase the
left to decrease.
11) Take one of the plastic cord clips and align
with the electrical cord hanging over the rim
of the bowl. With the two-prong end on the
cord clip all the way down until it clips onto
12) Take the other two plastic cord clips and
attach them to the bowl so that the three clips
together form the three points of a triangle.
Fig. 8a
Raised Notches
Fig. 8b
Fig. 10
Fig. 11a
Fig. 11b
Fig. 12
pg. 3
To Next Page
Loading...
