To Next PageTo Next Page
Need help?Do you have a question about the Drinkwell Platinum and is the answer not in the manual?
General| Capacity | 168 oz (5 Liters) |
|---|---|
| Filtration | Yes |
| Filters Included | Yes |
| Material | Plastic |
| Pump | Submersible |
| Type | Pet water fountain |
| Filter Type | Activated Carbon Filter |
Instructions to read before using the appliance.
Ensure close supervision of children when appliance is in use.
Only use attachments recommended or sold by the manufacturer.
The appliance is designed for indoor use only, not outdoors.
Grasp the plug to unplug the appliance, not the cord.
Do not operate if cord, plug, or appliance is damaged. Return for service.
Avoid placing portable appliances near tubs or sinks to prevent shock.
Unplug appliance when not in use, before part changes or cleaning.
Inspect the electrical cord for tears or damage before using the appliance.
Verify that the inline plug is properly connected with no silver showing.
Ensure the reservoir is lifted and the intake tube is properly inserted into the motor.
Insert the charcoal filter into the housing with the narrow side down and black side facing front.
Fill the fountain unit with water, including the bowl and filter housing, to prime the pump.
Fill the reservoir with water, screw on cap, and slide it into place.
Make sure hands and the cord are dry before plugging the fountain into the outlet.
Adjust the flow control knob to set the desired water stream strength.
Maintain water level to avoid motor burnout; use handles to lift.
First step in cleaning: unplug, remove cover, and pull out the filter.
Remove the reservoir and empty all water from the fountain.
Gently pull up the pre-filter by its lip and wash with soap and water.
Push in on the sides of the housing to remove it from the fountain.
Disconnect the inline plug to remove the motor from the fountain.
Cleaning the motor is essential for fountain longevity and water cleanliness. Warranty may be voided if not cleaned.
