Drinkwell Platinum - Fountain Disassembly & Cleaning; Unplug, remove cover and filter; Remove reservoir and empty fountain; Remove and wash pre-filter

FOUNTAIN:
1) Unplug fountain, remove cover and pull out
lter.
2) Remove the reservoir (See Operating
Instructions # 8)
3) Empty the water out of the fountain.
4) Removethepre-lterbygentlypullingup
onthetoplipofthepre-lterandwashwith
soap and water. (Fig. 2a)
FOUNTAIN DISASSEMBLY & CLEANING
The Fountain Must Be Cleaned To Continue Working Normally!
FILTERS:
1) Filtersshouldbechangedeveryfourtosixweeks.Replaceltersmore
frequently when using the fountain for multiple pets or pets that produce a
lot of saliva.
2) Filters are an added feature of the fountain. Their use is not required for
normal operation.
3) Filters may be rinsed out when the fountain is cleaned. Do not wash with
soapy water since you cannot remove all the soap residue.
4) Forreplacementlters,visitapetstorenearyouorcall866-322-2530.
5)Removethelterhousingbygentlypushinginoneithersideofthe
fountain where the curve meets the seam. Gently lift up. (Fig. 2b-d)
a. Note: You will notice the right side of the housing will offer some
resistance as the water intake tube pulls away from the motor.
p. 4
Fig. 2b
Fig. 2c
Fig. 2d
Fig. 2a
www.petfountain.com