Drinkwell Platinum - Page 6

4) Replacethepre-lterovertheow
control knob by sliding the narrow end in
rst.Theliponthetopofthepre-lterwill
be facing the front of the fountain, push
downtosnapitintoplaceovertheow
control knob.
5) Replacethelterandlid(SeeOperating
Instructions #5 & 7)
6) Replace the reservoir (See Operating
Instructions #8)
2) Thread the plug through the opening next to the motor. Under the arch
you can tuck the cord into “cord channels”, then thread the cord along
the back of the fountain to the cord notch (Fig. 3d). Use this pass-through
to keep the cord from showing.
Cord Channels
Cord Pass-Through
3) Lineupthelterhousingunitoverthemotorandthenthebowl.Youwill
wanttolineuptheintaketubetotdirectlyintothemotor.Onceinplace,
gentlypushdown,lockingthelterhousingintoplace.(Fig.3f)
Intake Tube
p. 6
Fig. 3c
Fig. 3d
Fig. 3f
Fig. 3e
Fig. 3g
www.petfountain.com