05
Button Instructions
Shut Down
Start Up
1. ON / OFF : Switch the unit ON / OFF. The unit runs in this order: “ON – OFF – ON”.
2. Humidity Up / Down : Press once to increase / decrease humidity by 1% respectively.
Press and hold for 1.5 seconds to increase the rate of adjustment.
3. Memory: Activate / Deactivate the memory function. The Memory Indicator shows the
status of this function. This function stores the last user setting for the Humidity.
If the power is cut o while this function is active, the unit stores the Humidity setting,
and will automatically revert to this setting when power is restored.
Press “ON / OFF” while the unit is running. The unit will stop running and all indicators will
be switched o. Please note that any stored humidity setting for the memory function
will also be erased.
1. Plug in the power cable and turn on the power. A beep will sound if the unit is
working correctly.
2. Press “ON / OFF”. The Operation Indicator will turn on, and the Humidity Display window
will display the humidity setting. The default humidity setting is 60%. If the Memory
function is active, the humidity setting will restored to the saved user setting. 3 seconds
later, the humidity display window will display the current humidity reading.
3. Press the Humidity Up / Down key to adjust the level of humidity. If the humidity setting
is above/below the current reading with a threshold of 3%, the unit will activate/
deactivate accordingly.
4. The unit will go into continuous mode and the Humidity Display will show “CO” when
the user sets the humidity setting below 30%.
To Next Page