EasyManuals Logo

Drive Medical Oxygen Pulse Oximeter User Manual

Drive Medical Oxygen Pulse Oximeter
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
888-606-8778
hartmedical.org
COVID-19 Guide
Oxygen Pulse Oximeter
The Drive Pulse Oximeter is used to measure the oxygen level in the blood
with a special photoelectric sensor that is painless and simple to use.
Important information you should know:
Uses 2 AAA batteries
Do not stare at the infrared light in the oximeter
Not intended for use on children 4 years and younger
Nail must be polish free
Nail must be short
Instructions:
Insert the two batteries properly to the direction, and then replace
the cover.
Open the clip.
Put the user’s finger into the rubber cushions of the clip with the
fingernail towards the top.
Clip the finger as shown in the picture.
Press the switch button once on front panel.
Do not shake the finger and remain at ease during the process.
Moving is not recommended during this process.
Review the information directly from screen display.
Record the % SpO2 number.
The pulse oximeter will power off automatically within 5 seconds
after removing your finger.
COVID-19 Monitoring Guide: Remember to write down all % SpO2 (oxygen sat) results
1. Always follow your doctor’s instructions when different than these outlined below.
2. Check oxygen saturation every 2 hours while awake.
3. If % SpO2 is less than 92% follow instructions from your doctor, or call your doctor.
4. Beginning on day 4 of oxygen therapy, check % SpO2 on room air, not using oxygen.
5. If result is less than 90%, continue using oxygen, and repeat test the next day
6. If result is 91% or higher, walk inside home or room for 1-2 minutes without oxygen, and then retest.
If result is 90% or lower, continue using oxygen, and repeat the test the next day.
If result is 91% or higher, stop using oxygen, and test oxygen level every 2 hours for 12 hours, and
record time and results.
If any result is 90% or less, continue using oxygen, and repeat testing step #6 the next day.
If oxygen level remains at 91% or higher, stop using oxygen, and call Hart Medical Equipment to
pick-up the oxygen. Hart Medical Equipment will request your testing results and send a notice to
your doctor.
Hart will contact you about a pick-up of your oxygen equipment and pulse oximeter after
confirming with your doctor.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Drive Medical Oxygen Pulse Oximeter and is the answer not in the manual?

Drive Medical Oxygen Pulse Oximeter Specifications

General IconGeneral
BrandDrive Medical
ModelOxygen Pulse Oximeter
CategoryMedical Equipment
LanguageEnglish

Related product manuals