Drive cruiser III - Operational Procedures; Folding and Armrest Removal; Critical Operational Warnings

TO CLOSE/FOLD CHAIR - First fold foot plates
to vertical position. Grab seat with both hands
at front and back edge and lift. Or, tilt chair to
one side and lift up on seat rail.
REMOVABLE ARMS - Remove arms by depress-
ing spring button and lifting arms out of front
and rear sockets.
WARNING
Do not attempt to adjust or operate wheelchair
without reading carefully all instructions in this
manual.
This wheelchair has not been approved as a
seat that can be used within vehicles of any
kind. Always transfer wheelchair user to a
vehicle manufacturers approved seat and use
safety restraints available.
Do not operate this wheelchair on roadways,
streets or any surfaces with vehicular traffic.
Do not attempt to operate on inclines 10° or
greater without proper assistance.
Be sure to completely engage wheel locks
when getting in and out of wheelchair or when
in elevator or wheelchair lift.
Wheelchair should be on a smooth, stable and
level area with wheel locks engaged before
transferring user in or out of wheelchair.
Do not adjust foot rests any lower than 2-1/2”
from floor.
When getting in or out of wheelchair, do not
stand on or apply weight to foot rests.
Before reaching or leaning forward, rotate cast-
ers to front of the wheelchair engage wheel
locks to help prevent wheelchair from tipping
over.