EasyManua.ls Logo

Drive OXYMIZER - OXYMIZER Pendant Device Maintenance and Specifications; Device Care and Replacement; Device Specifications

Drive OXYMIZER
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
REPLACEMENT:
The OXYMIZER Pendant device should
be replaced after approximately three
weeks. More frequent replacement may
be needed for cleanliness and sanitation,
depending on conditions of use.
You may also be interested in the original
OXYMIZER oxygen-conserving device
with the oxygen-saving mechanism
contained in a facepiece, which is ideal
for use at home (see illustration below).
72'$<·6'$7( REPLACE ON:
HUMIDIFICATION UNNECESSARY
Since less total oxygen is passing over
the nasal mucosa, the drying effect
of oxygen is significantly less and
supplementary humidification can usually
be eliminated. Since excessive moisture
could impede the membrane action of
the OXYMIZER Pendant device, use with
humidifiers should be avoided.
CODE #P-224
FOR USE IN OXYGEN THERAPY
DISPOSABLE-
FOR SINGLE PATIENT USE ONLY
DIRECTIONS FOR USE ENCLOSED
CONTENTS: One (1) OXYMIZER
Pendant disposable oxygen-conserving
device with curved tubular nasal
prongs, six (6) feet of connecting tube,
and a female connector.
ENGLISH
Inovo, Inc
401 Leonard Blvd. North
Lehigh Acres, FL 33971
Toll-free: 877-224-0946
www.drivemedical.com
&+$'7KHUDSHXWLFV
0DGHLQ&KLQD
30'
CLEANING
The disposal OXYMIZER oxygen-conserving
devices are clean and ready to use, and
are supplied in individual containers. The
outer surface may be cleaned with soap and
water, but care must be taken not to allow the
membrane within the reservoir to become wet.
DISPOSAL
Disposal for your device should be done in
accordance with local regulations.
SPECIFICATIONS
Max. Inlet Presure 50 psi
Max. Flow (LPM) 15 LPM
Operational Temp. 0°C to 50°C (32°F to 122°F)
Storage Temp. -40°C (-40°F) to 60°C (145°F)
0$18)$&785(')25

Related product manuals