assembly instructions
Do not attempt to adjust or operate Rollator without
carefully reading all instructions in this manual.
1. First remove all contents from carton: backrest,
handle with tube, Rollator frame and Basket.
2. Open frame and slide padded backrest into
frame brackets making sure snap bottoms
protrude through holes.
3. Unscrew tightening knob from handle and
insert handle tube into frame at desired
height lining up holes appropriately. Slide bolts
through holes from the inside and screw on
tightening knob until secure.
safety precautions
1. Please make sure the Rollator is fully opened,
seat is down and the folding bar under seat is locked
in the down position.
2. Be sure that both knobs are fully tightened and
are at equal heights. Test Rollator for stability before
applying full weight to hand grips.
3. Test the loop locks before operating the
Rollator. When wheels are locked (see
illustrations for locking and releasing locks below),
lock bar on rear wheels should prevent wheels from
turning. If the wheels turn while brakes are
locked, please take unit back to dealer for
adjustment. When locks are released,
the wheels should turn freely.
To Next Page
Loading...
