1. Take the Harness out of the package, unfold, and unbuckle the chest and waist.
2. Bring the harness over the user’s torso so the support handle sits in the middle back between the
shoulder blades, and the shoulder straps sit on each shoulder, like putting on a jacket.
3. To start: If waist belt rest at bottom of belly/belt line out of package, then leave here (option B).
• If waist belt rest above belly & under chest/bust, then leave here (option A).
• If waist belt rest at chest level, then lower to rest above belly & under chest/bust (option A).
• If waist belt rest in middle of round belly, and cannot be raised, then lower waist belt (option B).
• If waist belt rest in middle of flat belly, and cannot be raised, then leave here (between A & B).
• If waist belt rest at bottom of belly/past, with excess shoulder material, then consider downsizing.
Downsizing options: Any Large/Adult size harness to Medium/B’s & G’s size harness.
o Adults can fit into Medium/B’s & G’s sizes.
Avoid placing waistbelt in middle of belly if individual has a round belly, as this will slip and ride up
4. Adjust and fasten the waist belt. Adjust both sides simultaneously, ensuring the waist belt fits
SNUGGLY, but does not restrict movement. Excess waistbelt strap can be fed thru rear loophole if
applicable. *Note: Waist & Chest buckles may not sit center of body. This is ok!
5. CHEST STRAP: IMPORTANT STEP
Guide the chest straps under the arm pits, and
THROUGH the Chest Loop Guide (Silver
webbing w/ 3 in. loops sections) across the
upper portion of the chest, about halfway
between the chest line and the collar bone and
adjust for a snug fit.
DO NOT rest the chest strap on top of the
shoulder straps. It needs to be FED
through the Chest Loop Guide (Between
the Silver and Black Webbing).
6. Adjust Support Handle Adjuster (if applicable) up or down to work out the excess slack.
(Adjusting upwards increases response grab of harness, downwards decrease response grab)
7. Run your hands over the support harness to ensure there is no twisting or bunching. If a strap is not
lying correctly, remove your harness and refit as per the above instructions.
Please visit www.DropSupports.com for Instructional Video’s
To Next Page
Loading...