DSC PC1404 - Post-Configuration and System Checks; Personalizing and Transferring System; Performing System Checks

PC1404
Wiring Trikdis GT+ Cellular Communicator and
Programming the Panel
trikdis.com
Setting up the GT+ communicator with the app
Aer completing the setup and installation perform a
system check:
1. Create an event:
- by arming/disarming the system with the control
panel’s keypad;
- by triggering a zone alarm when the security
system is armed.
2. Make sure that the event arrives to the CMS
(Central Monitoring Station) and the Protegus app.
Step 9 Step 10 Step 11 Step 12
Enter system "Name".
Press "Next"
Press "Skip" Press on system
Wait 1 minute and press
"Transfer"
Step 13 Step 14
Enter the e-mail of the user
to whom the installer will
transfer the system. Press
"Transfer"
The system will appear in
Protegus on the user's
phone