DSC PC1832 - User Manual

PC1832
Wiring Trikdis GT+ Cellular Communicator and
Programming the Panel
• The communicator should be installed and maintained by qualified personnel.
• Prior to installation, it is advised to read full device installation manual carefully in order to
avoid mistakes that can lead to malfunction or even damage the equipment.
• Disconnect the power supply before making any electrical connections.
• Changes, modifications or repairs not authorized by the manufacturer shall void your rights
under the warranty.
CAUTION
Schematics forwiring the communicator
to the security control panel
Following the schematics provided below, wire the communicator to the control panel.
trikdis.com
DSC PC1832
EGND
T-1
R-1
Z8 Z6 Z4 Z2
COM COM COM COM GRN YEL BLK RED
AUX
- +
AC
-BELL+
PGM
2
1
Z7 Z5 Z3 Z1
TIP
RING

DSC PC1832 Specifications

General

Partitions	2
Event Buffer	500 events
Keypads	Up to 8
Backup Battery	12VDC, 7Ah
Zones	8 on board, expandable to 32
Communications	PSTN
Power Supply	16.5 VAC, 40VA transformer
PGM Outputs	2 (expandable to 14)
Wireless Zones	Yes, with wireless receiver
Communicator	Built-in PSTN dialer
Wireless Expansion	Yes, via wireless receiver module
Compatible Keypads	PK5500, PK5501, PK5508, PK5516, RFK5500, RFK5501, RFK5508, RFK5516
Weight	1.2 kg (without battery)

Summary

Schematics for Wiring the Communicator

LED Indication of Communicator Operation

Setting Up the GT+ Communicator with the App

Initial App and System Setup

Steps 1-4: Add new system, enter IMEI, select company, and press DSC.

Panel Configuration and Writing

Steps 5-8: Select panel, enter IDs, wait for configuration, and add to Protegus2.

Finalizing GT+ Communicator Setup

System Naming and Personalization

Steps 9-11: Enter system name, skip, and press on system.

System Transfer and Testing

Steps 12-14: Wait for transfer, transfer system, and perform system check.