Prog r am ming W orkshe e ts: 5.32 Walk Test (Installer)
[997] View Software Version
[998] Initiate Global Label Broadcast
All LCD programming is done per keypad. If more than one LCD keypad are present on the system, and the PC5400 receives
labels, labels programmed at one keypad can be broadcast to all other LCD keypads. Perform the following procedure in order to
broadcast labels:
Step 1 - Program one LCD keypad completely.
Step 2 - Make sure all LCD keypads are connected to the Keybus.
Step 3 - Enter Installer’s Programming, then enter section [998] at the keypad that was programmed. The keypad will now broad-
cast all the information programmed to all the other LCD keypads on the system.
Step 4 - When the keypad is finished press the [#] key to exit.
[999] Reset LCD EEPROM to Factory Defaults
ASCII Characters
To Next Page
Loading...
